Checking The Cover Function; Replacing The Carriage - Parker HMR 08 Series Assembly And Operating Instructions Manual

9.8

Checking the Cover Function

With the IP54 cover, the proper wiper function only occurs when a slight tread can be detected on the Outer band.
Scores or streaks of residue indicate defective or dirty wipers around the carriage. Replacement is required.
9.9

Replacing the Carriage

9.9.1 Disassembly of Carriage Ball Screw Drive
If present, the IP54 cover must be removed (refer to section 7.5.1 on page 17).
End cap drive end
► Loosen the carriage cover in the direction of the end cap drive end side in order to reach the screws
underneath.
► Place something such as wood underneath the screw.
► Loosen the screws from the end cap non drive end side and remove the cover.
► Remove the six screws of the nut slot.
► Carefully move carriage onto the guide rails with a parallel movement.
► Carefully move the carriage from the guide, without tilting, and insert the transport safety device such that
no balls fall out of the runner block.
Carriage cover
Nut slot
ATTENTION
Risk of damage to runner blocks
Tilting will damage the recirculating ball runner block!
Carriage
35
EN
End cap non drive end
Carriage
Runner block