Table of Contents
Advertisement
5
Transportation and Storage
5.1
Transportation
The electric HMR linear drives are extremely precise products. Impacts could damage the mechanical system of the
drive, resulting in a negative influence on functionality.
To prevent damage during transportation, place the units in appropriate protective packaging.
Lifted or suspended loads can tip over
This could result in severe injuries or damage to property.
► Never walk under suspended loads.
► Transport loads as close to the floor as possible.
► Securely fasten the load for transportation and note the center
of gravity.
This could result in severe injuries or damage to property.
► Hold parts or units securely.
► Wear safety gloves.
► Use tools and supports.
► Support the drive profile appropriately during transportation and
handling (e.g. with a bar).
Transport packed or unpacked HMR units using a crane or forklift
•
In storage and handling static deflection of the actuator should not exceed
0.1% of total length.
•
Larger deformations could result in a reduced service life, increased wear,
and increased friction. These must therefore be avoided!
•
Attach ropes as shown/use fork as shown.
Notify the shipping company and Parker-Hannifin GmbH or the
delivery company immediately, in writing, of any transportation
damage or missing parts.
5.2
Storage
The storage location must be:
•
Dry, free of dust and vibrations
•
On a flat surface.
Deflection of the HMR must be avoided!
•
Support the drive profile appropriately during transportation and handling.
WARNING
or crash down.
CAUTION
Heavy parts can slip during handling!
ATTENTION
The profile may bend or snap!
NOTE
7
EN
Advertisement
Table of Contents
