Table of Contents
Advertisement
7.2
Installation of Linear Drive
All installation measurements can be found under "6.3 Carrier profile and drive body" on page 8 and in the
HMR catalogue.
► During assembly, the HMR must be sufficiently supported and securely placed in a machine/system.
The maximum straightness and evenness in the running direction of the linear system can only be achieved if the
corresponding mounting points or surfaces are within the required tolerance.
The mounting surface for the profile version must have evenness of at least 0.2 mm/m at the clamping points.
7.2.1 Mounting with T-slots
► Use of T-slot profiles. Mounting from below.
Standard screws and sliding blocks or rails from the common profile systems can be used.
Mounting parts such as sliding blocks are available as accessories.
► Please observe the required number of T-sliding blocks in accordance with the axial holding force for
secure assembly (see table below and HMR catalogue page 38).
HMRS
T-slot mounting
Max, axial holding force per mounting set
T-slot
mounting
Product size
[N]
HMRx08
1,000
HMRx11
1,000
HMRx15
1,600
HMRx18
2,700
HMRx24
3,200
Dimension table - T-slot mounting HMR
Product size
A
B
HMRx08
8.0
4.0
8.0
4.0
HMRx11
HMRx15
10.5
6.4
HMRx18
13.5
6.7
16.5
8.9
HMRx24
ATTENTION
Straightness tolerance exceeded
The screw-on surface is important!
► Ensure evenness and straightness.
NOTE
► Adhere to the tightening torques for screws
according to section 7.1. on page 12.
min, number of sets
required per meter
horizontal horiz,
over head vertical
side
4
11
19
4
11
19
4
5
10
4
5
10
4
4
8
C
Ø D
M
N
11.5
M5
5.0
0.5 56351FIL
11.5
M5
5.0
0.5 56351FIL
22.5
M6
6.4
0.6 56351FIL
22.5
M8
8.5
1.0 56352FIL
28.5
M10
10.5
1.0 56353FIL
HMRB
T-slot mounting
5
5
5
5
5
Order no.
13
EN
Advertisement
Table of Contents
