Attaching The Payload - Parker HMR 08 Series Assembly And Operating Instructions Manual

Modular Electric HMR Linear Drives
7.3

Attaching the Payload

The user is responsible for the use of the HMR and makes decisions on the attachment of loads as well as the
operating status with speed, acceleration and frequency of movements. The HMR may only be installed according to
the catalog's specifications.
There are various threaded holes on the carriage available to the user of the HMR for mounting the payload.
The carriage has two dowel holes into which dowel sleeves can be inserted. This makes it possible to repeat the
disassembly/assembly of the payload without realignment.
Stop groove and centring for
the adapter sleeve are on the
same drive side
Dimension table - Carriage length Standard HMRS
R R T TA
Type
S L
HMRS08 128 -* 74 97
HMRS11 150 -* 96 122
HMRS15 191 -* 120 170
HMRS18 231 -* 150 202
HMRS24 291 -* 192 262
* in advance
Danger due to fracture or deformation of components,
incorrect arrangement of loads and crashing of loads
This could result in severe injuries and damage to property.
► Attach components according to technical rules.
► Move heavy parts with a hoist; wear safety gloves.
► Observe HMR catalog data with respect to arrangement.
ATTENTION
Risk of damage to the carriage
Additional holes will weaken or damage important
components and are not permitted.
► Do not drill or counter bore.
► Distribute load forces as required.
► Adhere to the tightening torques for screws according to section 7.1 on
page 12.
TA ta TB TB tb
S L S L
-* M4x12 70 -* M4x12
-* M5x12 97 -* M5x12
-* M5x12 122 -* M5x12
-* M6x12 170 -* M5x10 122
-* M8x16 202 -* M6x12 170
WARNING
NOTE
TC TC tc TD
S L S
40 -* M4x12 -
65 -* M5x12 25
- -* - 70
-* M5x10 90
-* M5x10 140
16
Centering/alignment of payload
Suitable dowel sleeves:
(packing unit 4):
Type Item no.
HMR-08 56455FIL
HMR-11 56455FIL
HMR-15 56455FIL
HMR-18 56457FIL
HMR-24 56459FIL
TD td TE TE te
L S L
-* - - -* -
-* M5x12 - -* -
-* M5x12 - -* -
-* M6x12 - -* -
-* M8x16 122 -* M5x10
TK U U1
H7
7 83 5,5
7 105 7,0
7 135 15,0
9 165 15,0
12 210 24,0