Assembly; Important Information - Parker HMR 08 Series Assembly And Operating Instructions Manual

Modular Electric HMR Linear Drives
7

Assembly

7.1

Important Information

HMR installation, and all other installations, may only be carried out by trained mechanical technicians or electricians.
The information in these instructions must be strictly observed.
Tightening torques for screws
Thread
M3
M4
M5
M6
M8
M10
Remarks regarding use and operation:
Mechanical
Additional drill holes or other machining may not be implemented on the HMR!
► Only attach the payload at the threaded holes on the carriage in section 7.3.
► Adhere to the permissible load limits such as weight, speed and acceleration.
► Adhere to the permissible load limits such as weight, speed and acceleration.
Combined loads
The maximum permissible load for linear drives subject to simultaneous multiple loads, forces and bending moments
are calculated using the formula below. Maximum permissible loads must not be exceeded.
Take note of the additional information in the Parker HMR catalogue on the "Maximum permissible load" on page 7.
Electrical information
► The controller, motor, position detection and all other necessary electrical elements
must be connected according to technical rules, within the responsibility of the operator.
► Do not place magnetic switches in the vicinity of ferritic parts or moving loads.
► Only use the seating grooves and/or the mounting holes on the aluminium profile for the
assembly and mounting of the profile version, as described in detail in the HMR catalog.
Tightening torque Tolerance
1.2 Nm ± 0.2 Nm
3 Nm ± 0.5 Nm
5.5 Nm ± 0.8 Nm
10 Nm ± 1.5 Nm
20 Nm
40 Nm
ATTENTION
Excessive forces or loads
Overload of the HMR would be possible
► Adhere to catalog data.
Fy Fz
L = +
Fy Fz
(max) (max)
The sum of all loads must under no circumstance be > 1.
± 3 Nm
± 6 Nm
Fz
Mz
My
Mx My Mz
+ + +
Mx My Mz
(max) (max) (max)
12
Mx
Fy
≤ 1