Qsfp+ Port Leds; Base-T Port Leds - Enterasys 7100G Series Hardware Installation Manual

Table 3-2 describes the LED indications for the port status LED for the QSFP+ ports and provides
recommended actions.
Table 3-2 QSFP+ Port LEDs
Color State
None No link. No activity. Port enabled or disabled.
Green (solid) Link present, port enabled, no traffic is being received
by the interface.
Yellow (blinking) Link present, port enabled, traffic is being received by
the interface.
Table 3-3 on page 3-3 describes the LED indications for the port status LED for the 1000 BASE-T
ports and provides recommended actions.
Figure 3-2 1000 BASE-T (RJ45) Port LEDS
1 Receive Port Status LED
Table 3-3 BASE-T Port LEDs
Rx Color Tx Color
None None
Green (solid) Green (solid)
Amber Green
(blinking/solid) (blinking)
Amber (solid)
2 Transmit Port Status LED
State
No link. No activity. Port enabled or
disabled.
Link present, port enabled, no traffic is
being received by the interface.
Link present, port enabled, traffic is being
received by the interface.
A transmit fault or error condition exists
Enterasys 7100G-Series Hardware Installation Guide 3-3
LEDs
Recommended Action
If you know the port should
be active and is not, contact
Enterasys Technical Support.
None.
None.
Recommended Action
If you know the port should
be active and is not, contact
Enterasys Technical Support.
None.
None.
Contact Enterasys Technical
Support if assistance is
required.