System Leds; 7100G-Series System Leds - Enterasys 7100G Series Hardware Installation Manual

LEDs

System LEDs

Figure 3-3
Figure 3-3
Table 3-4
Table 3-4 System LEDs
LED Color
FAN Off
Green
Red
CPU Off
Amber
Green
Red
Green
and
Amber
Amber
and off
3-4 Troubleshooting
shows the 7100G-Series system fan module, CPU, and power LEDs.

7100G-Series System LEDs

describes the LED indications for the system LEDs and provides recommended actions.
State
Fan module is off or booting up.
Fan module operating normally.
One or more of the following conditions has occurred:
• Temperature is out of range.
• The fan controller has failed.
• The fan module has failed.
Power off.
Blinking. Device in bootup process.
Solid. Testing.
Blinking. Image starts running.
Solid. Functional.
Solid. Processor in reset.
Blinking. Indicates that the 7100G-Series switch is in
the process of shutting down.
Alternating (67% on, 33% off). Indicates a shutdown
is complete. The indication will hold for 60 seconds
then automatically restart.
Recommended Action
None.
None.
Use the show system CLI command to
check the exact condition of the fan
module.
If the fan module has failed, replace the
fan module. See "Replacing the 7100G-
Series Fan Module" on page 3-8.
Ensure chassis has adequate power.
None.
If the LED remains amber for several
minutes, contact Enterasys Networks for
technical support.
None.
None.
None.
None. This state is activated when the
RESET button is pressed for less than
1 second to start an orderly shutdown.
While in this state, you have 60 seconds
before the 7100G-Series switch will
reboot.