Adjusting The Seat Depth With Replacing The Seat Support Plate - Invacare Storm4 X-plore User Manual

9.12.2.3 Adjusting the seat depth with replacing the seat support plate

Disassembly:
• Remove the legrests.
• Remove the armrests.
• Remove the seat cushion.
• Remove any cable ties which hold cables from the remote or lighting which have been fitted.
Remove the cables from any clips which have been glued on.
• Undo the cap nuts on the headlight holders with an 8 mm jaw spanner.
• Place the headlights including their holders safely on the rear section of the battery box cover.
• Remove the cover plates (1).
• Undo the two Allen screws (9) at the front on the seat support plate and remove them.
• Undo the two Allen screws (7) which are located on the side at the front of the seat support
plate, and connect these to the crossmembers (4).
• Undo the two Allen screws (8) which are located on the side at the rear of the seat support
plate, and connect these to the crossmembers (4).
• Remove the seat support plate (2).
• Repeat these operations on the other side of the seat.
• Undo and remove the two Allen screws (5) including washers.
Assembly:
• Pull the seat support to the required length so that the Allen screws (5) can be inserted in the
holes in accordance with the table (see above).
98