Budget Control; Pse Port Priority - Planet FGSW-2022VHP User Manual

12-port 10/100tx 802.3at poe + 4-port 10/100tx 802.3bt poe + 2-port gigabit tp + 2-port sfp ethernet switch with lcd management

Table of Contents

2.3.2 Budget Control

Due to the power allocation strategy of PSE, when the residual power of PoE is

too large, the power distribution of the port can be increased as much as possible

by increasing the power trimming of the PSE, so that the utilization of the PSE

power supply can be improved. There are four levels of budget control named

Unchanged (default), Add 5% PB, Add 10% PB and Add 15% PB.

1. The default PoE budget is 300W. If you hope to have a full load

of over 300W, please select Add 5% PB, Add 10% PB or Add

15% PB.

2. In order to make sure the PSE power supply is not overloaded for a long

Note

time, please try to ensure that TP is less than PB.

The Priority represents PoE ports priority. There are three levels of power priority

named Low, High and Critical. The priority is used in case the total power

consumption is over the total power budget. In this case the port with the lowest

priority will be turned off, and offer power for the port of higher priority. The

default port priority is "Low".

Table of Contents