Sport Recumbent Bike Assembly And Setup - Star Trac UB Sport Upright Bike Owner's Manual

SPORT RECUMBENT BIKE ASSEMBLY AND SETUP

Use the following procedures to unpack and assemble your STAR TRAC
SPORT UB / UBx RECUMBENT BIKE.
U
NPACKING
NOTE: Complete unpacking instructions are printed on the side of
the shipping carton.
Turn the shipping carton upside-down, and fully open all four
flaps on the bottom of the carton.
Turn the shipping carton right-side up, then lift the carton off of
the foam inserts. Remove all parts and foam inserts, and verify
that the following parts are included in your shipment:
Description
Bike Frame
Display Console Assembly
Seat Frame Assembly
Front Foot
Rear Foot
Pedals (set of two)
Screw, Button Head, M10 X 30
Screw, Flat Head, M6 X 16
Screw, Socket Head, M6 X 20
T R
OOLS EQUIRED
Most STAR TRAC bikes can be assembled using the following tools:
■
Metric Hex Key Wrenches
■
Metric Open-End Wrenches
■
Metric Ratchet Socket Wrench Set
■
Torque Wrench
Your STAR TRAC UB / Ubx SPORT RECUMBENT BIKE includes a hex key set and combination open-end wrench.
A
SSEMBLY
1. Install the Front Foot
NOTE: The front foot assembly has wheels attached to the front
edge. Be sure the wheels face forward when installing the front foot
assembly.
Stand the bike frame upright and place the front foot assembly
under the frame, aligning the holes in the foot with the holes in
the frame.
NOTE: It may be necessary to raise the frame slightly to align the
holes in the frame with the mating holes in the front foot.
Using four M10 X 30 button head screws, secure the front foot
assembly to the frame. Tighten all four screws securely.
14
Qty
1
1
1
1
1
1
8
4
4
■
Channel Lock Pliers
■
Vice Grip Pliers
■
Rubber Mallet
■
Phillips Head Screwdriver
STAR TRAC SPORT BIKES O
Step 1
' M
WNER S ANUAL