Wiring The Control Circuit Terminal - YASKAWA GA800 Series Installation & Primary Operation

10 Drive Start-Up Procedure
Wire Gauge
mm 2 (AWG)
0.25 (24)
0.34 (22)
0.5 (20)
◆

Wiring the Control Circuit Terminal

WARNING
Electrical Shock Hazard. Do not remove covers or touch circuit boards while the drive is energized. If you touch
the internal components of an energized drive, it can cause serious injury or death.
NOTICE
Do not let wire shields touch other signal lines or equipment. Insulate the wire shields with electrical tape or shrink
tubing. If you do not insulate the wire shields, it can cause a short circuit and damage the drive.
Note:
• Isolate control circuit wiring from main circuit wiring (terminals R/L1, S/L2, T/L3, B1, B2, U/T1, V/T2, W/T3, -, +1, +2, +3) and other
high-power wiring. If control circuit wiring is adjacent to main circuit wiring, it can cause incorrect operation of the drive and equipment
from electrical interference.
• Isolate wiring for contact output terminals MA, MB, MC and M1-M6 from other control circuit wiring. If contact output terminal wiring is
adjacent to other control circuit wiring, it can cause incorrect operation of the drive and equipment from electrical interference.
• Use a Class 2 power supply to connect external power to the control terminals. If the power supply for peripheral devices is incorrect, it can
cause a decrease in drive performance.
• Connect the shield of shielded cable to the applicable ground terminal. Incorrect equipment grounding can cause drive or equipment
malfunction from electrical interference.
Correctly ground the drive terminals and complete main circuit wiring before you wire the control circuit. Remove the
keypad and front cover.
1.
Push in on the tabs on the both sides of the LED status ring board to release the board from the bracket. Pull
the board forward to remove it.
NOTICE
in the holding position provided on the drive. If you cause damage to the LED status ring board, the LEDs will not function
correctly.
Note:
You can temporarily store the LED status ring board with the temporary placement holes on the drive. The location of the
temporary placement holes is different on different drive models.
A - Drive front
B - LED status ring board
60
Figure 10.4 External Dimensions of Crimp Ferrules
Table 10.7 Crimp Ferrule Models and Sizes
Model L (mm)
AI 0.25-8YE 12.5
AI 0.34-8TQ 12.5
AI 0.5-8WH,
14
AI 0.5-8OG
When you remove the LED Status Board from the drive bracket, make sure that you temporarily install it
Figure 10.5 Remove the LED Status Ring Board
L1 (mm)
8
8
8
C - Temporary placement holes
YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
φd1 (mm) φd2 (mm)
0.8 2.0
0.8 2.0
1.1 2.5