Disable The Initial Setup Screen; Control Circuit Terminal Block Functions - YASKAWA GA800 Series Installation & Primary Operation

◆

Disable the Initial Setup Screen

Do the steps in this procedure to not show the initial start-up screen when the drive is energized.
1.
Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
2.
Push (Menu).
3.
Push /
4.
Push /
5.
Push /
• [No]: The keypad will not show the Initial Setup Screen when the drive is energized.
• [Yes]: The keypad will show the Initial Setup Screen when the drive is energized.
◆

Control Circuit Terminal Block Functions

Hx-xx parameters set functions for the multi-function input and output terminals.
WARNING
Sudden Movement Hazard. Correctly wire and test all control circuits to make sure that the control circuits operate
correctly. If you use a drive that has incorrect control circuit wiring or operation, it can cause death or serious injury.
WARNING
Sudden Movement Hazard. Check the I/O signals and the external sequences for the drive before you set the
Application Preset function. When you set the Application Preset function (A1-06 ≠ 0), it changes the I/O terminal functions for the
drive and it can cause equipment to operate unusually. This can cause serious injury or death.
YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
, push
to select [Initial Setup], then push
to select [Show Initial Setup Screen], then push
to select [No], then push
(Back), and then push
.
.
.
10 Drive Start-Up Procedure
to show [Home].
55