Using The Hanging Brackets To Move The Drive; Installation Position And Distance - YASKAWA GA800 Series Installation & Primary Operation

◆

Using the Hanging Brackets to Move the Drive

Use the hanging brackets attached to the drive to temporarily lift the drive when you install the drive to a control
panel or wall or when you replace the drive. Do not let the drive stay vertically or horizontally suspended or move the
drive over a long distance while it is suspended.
Before you install the drive, make sure that you read these precautions:
WARNING Crush Hazard. Before you hang the drive vertically, use screws to correctly attach the drive front cover and other
drive components. If you do not secure the front cover, it can fall and cause minor injury.
WARNING
Crush Hazard. When you use a crane or hoist to lift the drive during installation or removal, prevent more than
1.96 m/s 2 (0.2 G) vibration or impact. Too much vibration or impact can cause serious injury or death from falling equipment.
WARNING
Crush Hazard. When you lift the drive during installation or removal, do not try to turn the drive over and do not
ignore the hanging drive. If you move a hanging drive too much or if you ignore it, the drive can fall and cause serious injury or
death.
WARNING Crush Hazard. When you install the drive, do not hold the front cover. Install the drive with holding the heatsink. If
you hold the front cover, the cover will come off and the drive will fall, then it can cause injury.
◆

Installation Position and Distance

Install the drive vertically for sufficient airflow to cool the drive.
Note:
Contact Yaskawa or a Yaskawa representative for more information about installing drive models on their side.
A - Vertical installation
■
Single Drive Installation
Use the clearances specified in
airflow.
A - 50 mm (2 in) minimum
B - 30 mm (1.2 in) minimum on both
sides
YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
Figure 6.1 Installation Position
Figure 6.2 to install the drive. Make sure that there is sufficient space for wiring and
Figure 6.2 Installation Distances for One Drive
B - Horizontal installation
C - 120 mm (4.7 in) minimum above
and below
D - Airflow direction
6 Mechanical Installation
19