Control Circuit Wire Gauges And Tightening Torques - YASKAWA GA800 Series Installation & Primary Operation

Figure 10.2 Tightening Torque Display Location (Reverse side of Front Cover)
Figure 10.3 Tightening Torque Display Location (Lower Front Side of Front Cover)
■

Control Circuit Wire Gauges and Tightening Torques

Use the tables in this section to select the correct wires. Use shielded wire to wire the control circuit terminal block.
Use crimp ferrules on the wire ends to make the wiring procedure easier and more reliable.
Terminal Block Terminal
TB1 S1 - S8, SN, SC, SP
TB2 M1 - M6，MA，MB，MC
+V，AC，-V，A1，A2，A3，
TB3
FM，AM，AC，MP，RP，AC
E (G)，SN，HC，H1，H2，PS，
TB4
AC，D+，D-
TB5 E (G)
Crimp Ferrules
Attach an insulated sleeve when you use crimp ferrules. Refer to
dimensions and model numbers of crimp ferrules.
Use the CRIMPFOX 6, a crimping tool made by PHOENIX CONTACT.
YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
Table 10.6 Control Circuit Wire Gauges and Tightening Torques
Screw Size
M3
M3.5
Bare Wire
Tightening
Torque
Recommended
Gauge
N∙m (in∙lb)
mm 2 (AWG)
0.5 - 0.6 0.75
(4.4 - 5.3) (18)
0.5 - 1.0 0.5 - 2
(4.4 - 8.9) (20 - 14)
Table 10.7 for the recommended external
10 Drive Start-Up Procedure
Crimp Ferrule
Applicable Recommended
Gauge Gauge
mm 2 (AWG) mm 2 (AWG)
• Stranded wire
0.2 - 1.0
(24 - 16) 0.5
• Solid wire (20)
0.2 - 1.5
(24 - 16)
1.25
-
(12)
Applicable
Gauge
mm 2 (AWG)
0.25 - 0.5
(24 - 20)
-
59