Siemens SICAM Q100 Device Manual page 315

Table 12-1
LED
RUN
H1
RUN
H1
RUN
H1
RUN
H1
RUN
H1
C
RUN
H1
C
RUN
H1
C
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Indications Signaled by LEDs on the Top Side of the Housing (cont.)
Boot loader was started because an error occurred in the process
ERROR
application.
H2
The IP address was configured or received from DHCP.
DHCP active (LED H1 switches off after reception of the IP address
via DHCP)
ERROR
H2
Boot loader started, process application is being loaded.
ERROR
H2
Double IP address is detected
ERROR
H2
Normal mode:
ERROR
IP address has been configured or received from DHCP.
H2
C
DHCP:
ERROR ERROR
LED RUN (green) is lit after the IP address was received from the DHCP
server.
H2
C
The default IP address was confirmed by pressing the F4 softkey.
ERROR
H2
C
Meaning
Process Application
12 Failures and LED Indications
12.3 Indications Signaled by LEDs
315