Cutting To Make It Possible To Cut Corners Attractively (Over Cut) - Roland TrueVIS MG-640 User Manual

Accurately Adjusting the Cutting Settings

Cutting to Make It Possible to Cut Corners Attractively (Over Cut)

Cutting the corners of the border of the cutting line slightly longer makes it possible to cut the corners
attractively.
This is effective when using laminated or thick media, or non-resilient media. It also has the effect of
making stickers easier to peel off.
Procedure
1.
Press [MENU].
2.
Press [▲] to display the following screen.
MENU
CUTTING MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
CUTTING MENU
OVER CUT
4.
Press [▶] to display the following screen.
OVER CUT
DISABLE DISABLE
5.
Press [▲] or [▼] to select "ENABLE".
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU] to return to the original screen.
MEMO
• Default setting: "DISABLE"
• The cutting start point is not over cut.
166
Optimizing the Output Quality