Using Account Codes - Inter-Tel 8664 User Manual

U A
SING CCOUNT
If your telephone system is programmed to use the Station Message Detail Recording
(SMDR) feature, you might be required to enter account codes when you place a call.
These codes add information to telephone record reports that the system will periodi-
cally print.
There are three types of account codes:
•
Standard account codes are automatically entered into the SMDR report when-
ever you place a call.
•
Forced account codes must be dialed before you can place an outside call.
•
Optional account codes can be entered at any time during a call.
NOTE:
Your system administrator can tell you which types of account codes are used
on your telephone system.
To enter an optional account code while on a call:
EITHER, Press
1.
OR, Press
Dial
2.
Dial the optional account code. If the account code is not immediately accepted,
3.
press
To set an account code for all calls placed from your endpoint:
While in idle mode, press
1.
Dial
2.
diately accepted, press
endpoint until it is disabled.
To disable the account code you set for your endpoint:
While in idle mode, press
1.
Dial
2.
®
Inter-Tel Model 8664/8665/8668 User Guide
C
ODES
.
-
7
FCN
until the softkey is available and then press the
Feat
FCN
.
3 9 0
.
#
MENU
and then the account code. If the account code is not imme-
3 9 1
. This code will be used for all calls made from your
#
MENU
and press
3 9 1
to bring up the two-line display.
to bring up the two-line display.
.
#
softkey.
Feat
75