Introduction; Turning Your Endpoint On And Off; Locking And Unlocking The Keypad On Your Endpoint - Inter-Tel 8664 User Manual

I
NTRODUCTION
Now that you know what your Model 8664/8665/8668 endpoint can do, it's time to
start using it. In this section, you'll learn how to make and receive calls, transfer calls,
retrieve voice mail messages, and much more.
T Y
URNING OUR
The and
as begin and end calls.
To turn the Model 8664/8665/8668 endpoint on:
Press and hold
sound. When the button is released, the in-service tone sounds and the extension num-
ber is displayed. The endpoint is now in idle mode and ready to receive calls.
NOTE:
It is recommended that you keep your endpoint in idle mode (see
always return it to the charger when you are not using it.
To turn the Model 8664/8665/8668 endpoint off:
While in idle mode press and hold
sound and the endpoint will turn off. The endpoint cannot be turned off during a call.
You must end the call before you can turn the endpoint off.
L
OCKING AND
POINT
To unlock the keypad:
Press the
Unlk
default.
To activate autolock:
See "Keypad Autolock" on
26
E O
NDPOINT N AND
buttons are used to power on and power off the endpoint as well
(the Power On button) for about one second. Two chirps will
U
NLOCKING THE
softkey, then . The autolock feature of the keypad is disabled by
#
page 58.
O
FF
(
the Power Off button). One chirp will
K Y
EYPAD ON OUR
®
Inter-Tel Model 8664/8665/8668 User Guide
page 12) and
E -
ND