Front Access Cover Assembly Removal - Lexmark C520 Series Service Manual

Front access cover assembly removal

1.
Remove 250-sheet tray.
2.
Remove right cover. See
3.
Remove transport belt. See
Note: In order to speed up the removal process, you can leave the photoconductor units on the transport belt
when removing. However, follow all warnings in regards to care of the photoconductor units.
4.
Remove four screws (A).
5.
Remove gearbox shield (B). There is a locking tab on the back of the gearbox shield.
Warning: When removing gearbox shield, be careful not to damage 5V interlock switch arm.
6.
Remove e-clip (C). Repeat for left side.
Note: Do not remove screws that attach pivot pin to front access door cover.
"Right cover removal" on page
"Transfer belt removal" on page
4-18.
4-15.
Repair information
5022-xxx
4-19