Lexmark C520 Series Service Manual page 69

Error Sub
Primary message
code code
34 xx Short Paper
34 xx Incorrect Media
35 xx Insufficient memory to
support Resource Save
feature
37 xx Insufficient memory to
collate job
37 xx Insufficient memory for
Flash Memory
Defragment operation
37 xx Insufficient memory,
some held jobs were
deleted
Action
• Press until Continue appears, and then press
message and continue printing.
The printer does not automatically reprint the page that prompted the
message.
• Check tray length and width guides to ensure media is properly fitted.
• Make sure the print job is requesting the correct size of media.
• Adjust the Paper Size setting for the media size being used.
If MP Feeder Size is set to Universal, make sure the media is large
enough for the formatted data.
• Cancel the current job. Replace paper pick mechanism. Go to
pick mechanism assembly removal" on page
• If problem still exists, replace system card. Go to
removal" on page 4-47.
• Load the appropriate media in the selected source.
• Press until Continue appears, and then press
message and print the job using a different paper source.
• POR printer to recalibrate transparency sensor.
• Ensure transparency sensor is mounted correctly in paper pick
mechanism. If not, snap into place.
• Replace paper pick mechanism. Go to
assembly removal" on page
• If problem still exists, replace system card. Go to
removal" on page 4-47.
• Press until Continue appears, and then press
Resource Save and continue printing.
• To enable Resource Save after receiving this message:
- Make sure the link buffers are set to Auto, then exit the menus to
activate the link buffer changes.
- When Ready is displayed, enable Resource Save.
• Install additional memory.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
portion of the job already stored and begin collating the rest of the job.
• Cancel the current job.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• Press until Continue appears, and then press
defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
• If this does not fix the problem, replace system card. Go to
card removal" on page
• The printer deleted some held jobs in order to process current jobs.
• Press until Continue appears, and then press
message.
• If this does not fix the problem, replace system card. Go to
card removal" on page
4-30.
"System card
"Paper pick mechanism
4-30.
"System card
4-47.
4-47.
4-47.
4-47.
Diagnostic information
5022-xxx
to clear the
"Paper
to clear the
to disable
"System
to print the
"System
to stop the
"System
to clear the
"System
2-11