Lexmark C520 Series Service Manual page 152

5022-xxx
Menu item Purpose
Auto Color Adj Sets the suggested number
of pages which the printer
should print between
consecutive calibrations.
Enforce Color Lets the system support
Order person set whether the
color order of the cartridges
inside the printer is
enforced and if messages
appear.
From top to bottom, as
indicated by the color labels
in the printer, the enforced
toner cartridges order is
yellow, cyan, magenta, and
black.
Color Alignment Prints the Print Alignment
Page and requires that the
best line in each set of lines
must be selected.
Motor Calibration Allows for speed calibration
after resetting the fuser
maintenance counter.
3-20
Service Manual
Values and descriptions
100–1000 (500*)
Off
On*
Off
No values exist for this operation.
Press Select to begin printing.
No values exist for this operation.
Press Select.
Increases in increments of 50.
If the printer exceeds the set value
while printing a job, it completes the
current job and any other jobs
received while printing the current
job before it initiates a calibration.
The printer does not cancel or
suspend an active job in order to
perform a calibration.
If a user is in any of the menus,
including the Configuration Menu
and the Diagnostics Menu, an
automatic color adjust calibration
does not occur.
When On is selected, the printer
lets users place each toner
cartridge in only its specified slot,
for instance the Magenta toner
cartridge must be in the Magenta
slot. Then, if the user tries to place
a cartridge in an incorrect slot, the
printer message 31 Defective
or Missing [color] Cartridge
or 32 Unsupported [color]
Cartridge appears where [color]
stands for Cyan, Magenta, Yellow,
and Black.
When Off is selected, the printer
does not issue any message to let
the user know that the cartridge is
placed in the wrong slot inside the
printer.
Once the page prints, follow the
instructions on the operator panel
to chose the best appearing line
numbered 0–20 for the following
sets of lines.
Set A
Set B
Set C
Set D
Set E
Set F
Set G
Set H
Set I
Set J
Set K
Set L
For each of the sets listed, the sub-
value is 0–20 (10*).
The Calibrating message
appears.
The printer prints several blank
pages and then returns to the
CONFIG MENU.