Tab: Setup - Toshiba 5000 Series Installation And Operation Manual

12.14

Tab: Setup

The SETUP tab allows the user to adjust certain UPS parameters. The setup tab shows 12 buttons. Inactive buttons are
indicated with a "x" in the lower right-hand corner of the button. The table below, right, shows a typical SETUP button.
Param.
Prefix
0 UPS Identification, Serial number, Start-up Date, software version
1 Input line-line V/I values, V/I percent of rated value, and frequency
2 Output line-neutral V/I values, V/I percent of rated value, and frequency
3 Bypass line-neutral V/I values, V/I percent of rated value, and frequency
4 DC Bus Voltage, DC Over Voltage Level, Over current detection Level, DC Bus Boost
Level
5 Battery Voltage/Current and Shutdown Voltage
6 Control and Configuration – UPS time/date/status, faults, warnings, password manage-
ment
7 History – UPS Operation time, Number of Faults, Backup, Operations.
8 Display and Ext Comm. – Disp. S/W version, buzzer status, display calibration values.
RemotEye I/P address, data and network status.
5000 Series 3P1 Industrial UPS Installation and Operation Manual – 92973-001
Parameter Category
FIGURE 12.11: PARAMETER CATEGORIES
Typical Significance
Button
No "x" in the lower right corner
indicates the button is active.
Pressing the button will open
a data page displaying the
parameters available at the
current security level.
A button that has an "x" in the
lower right corner is inactive
and cannot be accessed at the
current security level.
55