Siemens SINUMERIK 840D sl Function Manual page 192

W1: Tool offset
2.15 Sum and setup offsets
The effect of the parameters is similar to the wear (additive to the tool geometry). Up to six sum/
setup parameters can be defined per cutting edge parameter.
Tool geometry parame‐
ters
(to which the compensa‐
tion is added)
Length compensations
$TC_DP3
$TC_DP4
$TC_DP5
Radius compensation
$TC_DP6
$TC_DP7
Other compensations
$TC_DP8
$TC_DP9
$TC_DP10
$TC_DP11
192
Sum / setup parameters
Length 1
$TC_SCP13, $TC_SCP23,$TC_SCP33,
$TC_SCP43,$TC_SCP53,$TC_SCP63
$TC_ECP13, $TC_ECP23,$TC_ECP33,
$TC_ECP43,$TC_ECP53,$TC_ECP63
The numbers in bold, 1, 2, ... 6, designate the parame‐
ters of a maximum of six (location-dependent or similar)
compensations that can be programmed with DL =1 to
6 for the parameter specified in column one.
Length 2
$TC_SCP14, $TC_SCP24,$TC_SCP34,
$TC_SCP44,$TC_SCP54,$TC_SCP64
$TC_ECP14, $TC_ECP24,$TC_ECP34,
$TC_ECP44,$TC_ECP54,$TC_ECP64
Length 3
etc. ...
Radius
Corner radius
Length 4
Length 5
Angle 1
...etc.
Angle 2
$TC_SCP21, $TC_SCP31,$TC_SCP41,
$TC_SCP51,$TC_SCP61,$TC_SCP71
$TC_ECP21, $TC_ECP31,$TC_ECP41,
$TC_ECP51,$TC_ECP61,$TC_ECP71
The numbers in bold, 2, 3, ... 7, designate the parame‐
ters of a maximum of six (location-dependent or similar)
compensations that can be programmed with DL =1 to
6 for the parameter specified in column one.
Tool wear param‐
eter
$TC_DP12
$TC_DP13
$TC_DP14
$TC_DP15
$TC_DP16
$TC_DP17
$TC_DP18
$TC_DP19
$TC_DP20
Function Manual, 06/2019, A5E47435126B AA
Tools