Partial Eq; Output; Control - Roland Groovebox MC-707 Reference Manual

Parameter List
Curve Type 32–36 (other variations)
32 33
36
How to Apply the LFO
Apply the LFO gradually after the key is pressed
Fade Mode: ON-IN
Delay
high (more)
Time
Pitch
Cuto Frequency
Level
Pan
Note on
low (less)
Apply the LFO immediately when the key is pressed, and then
gradually begin to decrease the effect
Fade Mode: ON-OUT
high (more)
Delay Time
Pitch
Cuto Frequency
Level
Pan
Note on
low (less)
Apply the LFO gradually after the key is released
Fade Mode: OFF-IN
Delay
high (more)
Time
Pitch
Cuto Frequency
Level
Pan
Note Note
on o
low (less)
Apply the LFO from when the key is pressed until it is released, and
gradually begin to decrease the effect when the key is released
Fade Mode: OFF-OUT
high (more)
Pitch
Cuto Frequency
Level
Pan
low (less)
Note on
Note o

PARTIAL EQ

Parameter Value
Switch OFF, ON
Low Gain -24.0–+24.0 [dB]
72
34 35
Fade Time
Fade Time
Depth
Fade Time
Depth
Delay
Fade Time
Time
Depth
Explanation
Turns the equalizer on/off for each partial.
Gain of the low frequency range.
Parameter
Mid Gain
High Gain
Low Frequency
Mid Frequency
High Frequency
Mid Q

OUTPUT

Parameter
Output Assign
Chorus Level Send
Depth
Reverb Level Send

CONTROL

Parameter
Envelope Mode
Damper Free Note
DF Decay Offset
Receive Bender
Receive Expression
Receive Hold-1
Redamper Switch
Soft EQ Sens
Value Explanation
Specifies the reference frequency of the mid-
-24.0–+24.0 [dB]
frequency range.
-24.0–+24.0 [dB] Gain of the high frequency range.
20–16000 [Hz] Frequency of the low range.
Adjusts the amount of mid-frequency boost/
20–16000 [Hz]
cut.
20–16000 [Hz] Frequency of the high range.
Specifies the width of the mid-frequency
range.
0.5–16.0 (0.1step)
Set a higher value for Q to narrow the range
to be affected.
Value Explanation
Specifies how the sound of each partial will
DRY, MFX
be output.
Specifies the level of the signal sent to the
0–127
chorus for each partial.
Specifies the level of the signal sent to the
0–127
reverb for each partial.
Value Explanation
If this is set to SUSTAIN, the Envelope Level 3 is
held from when the envelope Time 3 has elapsed
until note-off.
When note-off occurs, the envelope transitions
from the current value to the Time 4 segment
NO-SUS, SUSTAIN
(release segment).
If this is set to NO-SUS, the envelope transitions
to the release segment after passing Time 3
regardless of the note-off timing, operating
according to the times specified by the envelope.
For notes above the specified note number,
the Envelope Mode operates as NO-SUS.
OFF, 1–127
Use this to simulate the undamped region of
a piano sound.
Specifies a fine adjustment to the time over
-100–+100 which the sound decays when the Damper
Free Note effect is applied.
Specifies for each partial whether MIDI pitch
OFF, ON bend messages are received (ON) or not
received (OFF).
Specifies for each partial whether MIDI
OFF, ON expression messages are received (ON) or not
received (OFF).
Specifies for each partial whether MIDI hold
OFF, ON 1 messages are received (ON) or not received
(OFF).
If Redamper Switch is ON, you can perform
the Half Damper operations used for piano
sounds.
However, the following conditions must be
OFF, ON
satisfied in order to use this operation.
5
Envelope Mode is NO-SUS
5
Amp Envelope's Level 1 and2 are 1 or greater
5
Amp Envelope's Times are Time 3 > Time4
Increases the proportion by which the EQ's
HighGain is lowered by the amount of pedal.
0–100
With a setting of 0, this has no effect.