Siemens SIMOCODE pro C System Manual page 295

Event Description
(alphabetical)
Initialization The initialization module is
module write- completely or partially write-
protected, protected.
parameter
Reparameterization of
changes not
SIMOCODE pro is denied
allowed
because the initialization module
is write-protected.
Initialization Reparameterization has been
module - rejected because the initialization
identification module is write-protected.
data write-
protected
Initialization The parameters of the
module read initialization module were read
in into SIMOCODE.
Initialization The reparameterization was
module accepted in the initialization
programmed module.
Initialization The initialization module has
module been cleared and is now back in
cleared the as-delivered condition.
Internal Internal ground-fault monitoring
ground fault has responded. An impermissibly
high residual current is flowing.
No start The permissible number of starts
permitted in the monitoring timeframe has
been attained. The next start
should not be carried out until the
interlocking time has expired.
Module fault At least 1 SIMOCODE pro
module is not ready for use.
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
Troubleshooting
Deactivate write protection
of the initialization module
Select a
•
parameterization with
identical addressing
and I&M data
Deactivate the partial
•
write protection of the
initialization module
Please check the motor
connection cable for
damage.
Connecting cable
•
defective or incorrectly
connected
Module defective.
•
Replace the module.
See Chapter
Replacing
SIMOCODE pro
components
(Page 279).
Commissioning, service, troubleshooting
13.4 Troubleshooting
Acknowledgment / Contactor
fault rectification control
Reset Tripped
Reset Tripped
Clear the fault; Tripped
reset
Error
No.
1)
28
1
295