Siemens SIMOCODE pro C System Manual page 169

Connecting the Y connecting cable to the basic unit and to the current measuring module or
to the current / voltage measuring module
● Connect the connector in the middle of the Y connecting cable (1) on the basic unit
● Connect the connector at the end of the Y connecting cable (2) to a current measuring
module or current / voltage measuring module
● If you are using a decoupling module:
– Connect the connector at the end of the initialization cable (2) on the decoupling
– Connect the decoupling module with a system interface connecting cable to the
Figure 9-4
SIMOCODE pro
System Manual, 05/2019, A5E40507475002A/RS-AD/004
module.
current / voltage measuring module.
Connecting the Y connecting cable to the basic unit and to the current measuring
module or to the current / voltage measuring module
9.4 Mounting, wiring, interfaces, compartment identification
Compartment identification
169