Siemens SIMOCODE pro C System Manual page 176

Accessories
Memory module
Enable all system parameter settings to be backed up and transferred to a new system
without the need for additional resources or specialist expertise, for example, if the device is
replaced (see also Chapter Replacing SIMOCODE pro components (Page 279)).
Note
Memory module type
• The SIMOCODE pro C and SIMOCODE pro V PB basic units up to product version *E08*
only support the 3UF7900* memory module.
• The SIMOCODE pro S, SIMOCODE pro V MR and SIMOCODE pro V PB basic units
support all memory modules as from product version *E09*.
• A 3UF7901* memory module is required for the SIMOCODE pro V PN and
SIMOCODE pro V EIP basic units. The 3UF7900* memory module is not supported.
Initialization module
The initialization module enables all system parameter settings to be backed up and
transferred to a new system without the need for additional resources or specialist expertise,
for example, if the device is replaced. It can be installed permanently in the switchboard.
Note
Basic unit support
The SIMOCODE pro S and SIMOCODE pro V PB basic units (as from product
version *E09*) support the initialization module.
Further information: See Chapter Compartment identification (Page 159).
Addressing plug
For "hardware" assignment of the PROFIBUS DP address without PC/PG on
SIMOCODE pro via the system interface. Setting the PROFIBUS DP address with the
addressing plug: See Chapter Setting the PROFIBUS DP address (Page 258).
Connecting cable
Different types and lengths of connecting cable are available. It is required to connect the
basic unit to its current measuring module and, if applicable, to its expansion modules or the
operator panel.
Note
The total length of all cables must not exceed 3 m on either of the system interfaces of the
basic unit!
176
System Manual, 05/2019, A5E40507475002A/RS-AD/004
SIMOCODE pro