Table of Contents
Advertisement
Figure 3-1
Performing short compensation
3. Fasten the electrode securing screws.
Do not fasten the screws too tightly to prevent the electrodes from damaged.
NOTE
4. Follow the instruction manual that came with your instrument to perform a
Performing Load Compensation
Generally, there is no need to perform load compensation. If you have any
standard device or you need to keep consistency in measured data, perform load
compensation.
The load compensation procedure is as follows.
1. Fasten the electrode securing screws at the HIGH and LOW sides with load
Do not fasten the screws too tightly to prevent the electrodes from damaged.
NOTE
2. Follow the instruction manual that came with your instrument to perform a
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
measurement to obtain short compensation data.
leads caught in the electrodes.
measurement to obtain load compensation data.
Performing Fixture Compensation
Operation
21
Advertisement
Table of Contents
