Supplemental Performance Characteristics; Additional Error - Agilent Technologies 16047E Operation And Service Manual

Supplemental Performance Characteristics

This section provides useful data on the 16047E. These supplemental performance
characteristics should not be considered specifications.

Additional Error

Additional errors are calculated as follows.
|Z| Measurement
Additional error Ze [%] of the |Z| measurement is calculated by substituting the
values in the table below into the following equation.
Ze [%] = ± {A + (Zs/Zx + Yo ×Zx) × 100}
where
A [%]
Yo [S]
Zs [Ω]
Zx [Ω]
Without extension cable
Applicable Instruments : 4294A
Yo
Zs
≤
A
f
f > 15MHz
where f is the measurement frequency (MHz).
Without extension cable
Applicable Instruments : 4192A, 4194A, 4263B, 4268A, 4278A, 4279A, 4284A,
4285A, 4338B
Yo
Zs
A
where f is the measurement frequency (MHz).
Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Specifications and Supplemental Performance Characteristics
Supplemental Performance Characteristics
Additional Error (Proportional Error)
Open Repeatability (Admittance)
Short Repeatability (Impedance)
Measured Value (Impedance)
µ
2 n + 10 × ( f / 100 ) [S]
2 m + 600 m × ( f / 100 ) [Ω]
15 MHz
0.2 % × ( f / 10 )
4 % × ( f / 100 ) [%]
µ
2 n + 10 × ( f / 100 ) [S]
2 m + 600 m × ( f / 100 ) [Ω]
0.2 % × ( f / 10 )
2
[%]
2
[%]
27