Fuser Temperature - Lexmark Optra E 4026-0 Series Reference Handbook

Bottom Margin
This margin can be set between -26 and +7. Moving the number
in a positive direction moves the margin down and narrows the
bottom margin. Moving the number in a negative direction moves
the text up the page and leaves a wider bottom margin. Changing
the bottom margin does not affect the top margin.
5. Verify your settings by running a Diagnostics Test Page.

Fuser Temperature

Use this procedure to adjust the fuser temperature. Adjusting the fuser
temperature may solve customer problems with paper curl, use of low
grade paper, and letterhead melting on some types of paper.
Temperature offsets of +5, 0 and -5 degrees centigrade can be set for
all the paper trays or for manual.
You can use either the diagnostic service diskette or the internal WPS
Diagnostic Toolkit, if installed.
1. Select Setup from the menu.
2. Select Diagnostics Test Page from the Commands Description
List.
3. Fuser temperature offsets for trays and manual will be printed in
the diagnostic information block on the test page.
4. Select one of the following from the Commands Description List
to change the fuser temperature and send to the printer.
For the paper trays, select:
• Set Tray Fuser Temp to -5 (-5 degrees C shift)
• Set Tray Fuser Temp to 0 (0 degrees C shift)
• Set Tray Fuser Temp to +5 (+5 degrees C shift)
For manual paper feed or envelopes, select:
• Set Manual Fuser Temp to -5 (-5 degrees C shift)
• Set Manual Fuser Temp to 0 (0 degrees C shift)
• Set Manual Fuser Temp to +5 (+5 degrees C shift)
7-17
4047-05W