Lexmark Optra E 4026-0 Series Reference Handbook page 136

Operator Codes (Continued)
Code Message or Symptom
27 Change Paper, Possible
locations:
27 Tray 1
27 Tray 2
27 Change Paper, Possible
location:
27 Tray 3
28 Load Envelope Feeder
29 Output Bin Full, top bin only
32 Print Cartridge Missing
37 Insufficient Memory
38 Memory Full
39 Complex Page
51 Defective Flash
52 Flash Full
54 Serial Port Disabled
56 Parallel Port Disabled
Action
Be sure the correct paper size is
installed.
Refer to the "Paper Jam 27, Paper
Size/Change Paper Service
Check" in the Service Manual.
Refer to the "Paper Deck Lifting
Plate Service Check" in the
Service Manual.
Be sure the correct envelope size
and weight is installed. Replace
PS931 paper sensor on the
envelope driver board.
Remove the paper from the output
face-down bin. Check and replace
if necessary:
• Paper Full Lever
• Switch Sensor Board
Be sure the print cartridge is
properly installed. Clean or
replace the high voltage power
supply contacts.
No service required, refer to
operator manual.
No service required, refer to
operator manual.
No service required, refer to
operator manual.
Go to Diagnostic Aids and run the
device tests. Replace Flash SIMM
J-7 if necessary.
No service required, refer to
operator manual.
No service required, refer to
operator manual.
No service required, refer to
operator manual.
6-9
4040