Lexmark Optra E 4026-0 Series Reference Handbook page 201

Error Code Message Table (Continued)
Error Code
32 Wrong Print Cartridge
installed
37 Insufficient Collation Memory
38 Memory Full
39 Complex Page
43 Font Card Not Supported
44 Defective Font Card
47 Font Card Removed While
Printing
51 Defective Flash
52 Flash Full
53 Unformatted Flash
54 Serial Error
56 Serial Port Disabled or,
Parallel Port Disabled
57 Check Duplex Connection
8-4
Laser Printer Reference Handbook
Explanation
The installed print cartridge is not
supported by the Optra printer.
Memory is too full to collate the print job.
Memory used to store pages is full. To
verify that the printer recognizes all the
installed memory, go to the user menus
and print the "Print Menus" test page.
Make sure the memory shown on the
printout matches the installed memory.
Page too complex to print.To verify that
the printer recognizes all the installed
memory, go to the user menus and print
the "Print Menus" test page. Make sure
the memory shown on the printout
matches the installed memory.
Font card format not supported by printer.
Defective font card installed in font slot.
Printer needs data on removed card.
The printer detects a defective Flash
SIMM. If the error recurs replace the
Flash SIMM.
Not enough flash memory for data
requested to be stored.
Flash problem at POR or while attempting
to write.
Framing or parity error on serial.
Data has been sent to a port which has
been disabled in the Setup Menu. The
port can be reactivated by entering the
customer setup menu and selecting Serial
Setup or Parallel Setup, Serial Buffer or
Parallel Buffer, and changing the setting
from Disabled to Auto.
The duplex unit has been electrically
disconnected from the printer but the
printer top cover is not open. Check the
auto-connect plugs on the duplex unit and
the printer.