Lexmark Optra E 4026-0 Series Reference Handbook page 252

Message
39 Complex Page
41 Waste Bottle
Full or Missing
42 Oil Bottle Empty
or Missing
43 Photo-
conductor Unit
Missing
44 Fuser Life
Exhausted
45 Paper Feed
Mechanism
Missing
46 Toner Cartridge
Not Correctly
Installed
47 Photo-
conductor Life
Exhausted
51 Defective Flash
52 Flash Full
Action
The amount of text, graphics and print information on
the page requires more time to print. You can either
select RESET or CONTINUE.
Try the following:
• If Page Protect is Off, set it On and try again.
• Reduce the complexity of the page by using fewer
fonts, macros and graphics.
• Delete unnecessary downloaded fonts or macros.
• If you are using scalable fonts, try reducing the point
size.
If Auto Continue is On when the printer detects this
error, it waits 30 seconds and then continues.
You may need more memory to print this level of
complexity.
Install an empty toner waste bottle.
Install a new oil bottle.
Install a photoconductor unit.
Call your service representative to install a new fuser.
Open, unlatch, and close the paper feed unit door.
Tray reseating the cartridge. If unsuccessful, replace it.
Replace the Photoconductor Unit.
Remove the defective flash memory card and try
another.
There is not enough free space in the flash memory
card to hold the data that was sent. You can either
select RESET or CONTINUE.
If you continue, whatever has not yet been stored in
flash memory will be ignored.
If Auto Continue is On when the printer detects this
error, it waits 30 seconds and then continues.
9-17
5045