Software Version; Password Input; Password Set - Delta VFD-B Series Manual

U (User-defined unit) = Frequency Command * K (Pr.00-05)
H (actual output) = Actual output frequency * K (Pr.00-05)
Example:
A conveyor belt runs at 13.6m/s at motor speed 60Hz.
K = 13.6/60 = 0.23 (0.226667 rounded to 2 decimals), therefore Pr.00-05=0.23
With Frequency command 35Hz, display shows LED U and 35*0.23=8.05m/s.
(To increase accuracy, use K=2.27 or K=22.67 and disregard decimal point.)
00 - 06

Software Version

Settings
Display
00 - 07

Password Input

Settings
Display
The function of this parameter is to input the password that is set in Pr.00-08. Input the correct password
here to enable changing parameters. You are limited to a maximum of 3 attempts. After 3 consecutive failed
attempts, a blinking "PcodE" will show up to force the user to restart the AC motor drive in order to try again
to input the correct password.

Password Set

00 - 08
Settings
Display
To set a password to protect your parameter settings.
If the display shows 00, no password is set or password has been correctly entered in Pr.00-07. All
parameters can then be changed, including Pr.00-08.
The first time you can set a password directly. After successful setting of password the display will show 01.
Be sure to record the password for later use.
To cancel the parameter lock, set the parameter to 00 after inputting correct password into Pr. 00-07.
The password consists of min. 2 digits and max. 5 digits.
Revision 10/2005, BE13, SW V4.08
Read Only
#.##
00 to 65535
00~02 (times of wrong password)
00 to 65535
00 No password set or successful input in Pr. 00-07
01 Password has been set
Chapter 5 Parameters VFD-B Series
Factory Setting: 00
Factory Setting: 00
Unit: 1
Unit: 1
5-27