Customer Instruct And Technical Faults - Jenn-Air W11356996 Service Manual

DIAGNOSTICS & TROUBLESHOOTING
DISPLAYED MESSAGE
ADD PRE-GROUND COFFEE,
PRE-GROUND MAXIMUM ONE
MEASURING CUP
EMPTY GROUND CONTAINER
DESCALING NEEDED, PRESS OK TO START
(~45 MIN)
ESC
FILL BEAN CONTAINER
FILL WATER TANK WITH FRESH WATER
GENERAL ALARM: REFER TO USER
MANUAL
SELECT A MILDER TASTE OR REDUCE
PRE-GROUND COFFEE QUANTITY
ESC
GROUND TOO FINE.
ADJUST GRIND LEVEL 1 CLICK WHILE IN
OPERATION
INSERT BREWING UNIT
INSERT MILK CONTAINER
INSERT GROUND CONTAINER AND DRIP
TRAY
n
2-4 JennAir Built-in Coffee System
For Service Technician Use Only

Customer Instruct and Technical Faults

POSSIBLE CAUSE
The "Pre-ground coffee" function has been
selected, but without placing any
pre-ground coffee in the funnel.
The funnel for pre-ground coffee is
clogged.
A "Tall" coffee with pre-ground coffee has
been requested.
The grounds container is full.
Indicates that descaling is needed.
OK
The bean container is empty.
The water tank is empty or incorrectly
positioned.
The inside of the coffee system is very
dirty.
Too much coffee has been used.
The grinding is too fine and the coffee is
delivered too slowly or not at all.
If the water filter is present, an air bubble
may have been released inside the circuit,
obstructing delivery.
After cleaning, the infuser has not been
replaced.
The milk container is not inserted correctly. Insert the milk container as far as it will
After cleaning, the grounds container has
not been replaced.
SOLUTION
Place pre-ground coffee in the funnel and
repeat delivery.
Empty the funnel using the brush
provided.
Place pre-ground coffee in the funnel and
press to continue and complete
OK
delivery.
Empty the grounds container and drip
tray, clean and replace them.
IMPORTANT: When removing the drip
tray, the grounds container must always
be emptied, even if it contains a few
grounds. If this is not done, when you
make the next coffees, the grounds
container may fill up more than expected
and clog the machine.
Press to start descaling or press
OK
to descale later. The descaling
ESC
procedure described in the "Descaling"
section needs to be performed.
Fill the beans container.
Fill the tank with fresh water and or insert
it correctly pushing it as far as it will go
until it clicks into place.
Clean the inside of the appliance
thoroughly. If the message is still displayed
after cleaning, contact an authorized
Customer Service Center.
Select a milder taste by pressing
reduce the quantity of pre-ground coffee
(maximum one measure).
Repeat coffee delivery and turn the
grinding adjustment dial one click
clockwise towards number seven while
the coffee mill is in operation. If after
making at least two coffees delivery is still
too slow, repeat the correction procedure,
turning the grinding adjustment dial
another click. If the problem persists,
make sure the water tank is fully inserted.
Insert the hot water/steam spout in the
appliance and deliver a little fresh water
until the flow becomes regular.
Insert the infuser.
go.
Remove the drip tray and insert the
grounds container.
or