Furuno FAR-3210 Instruction Manual page 72

1. INITIAL SETTING AND ADJUSTMENT
[Scale Resolution]: Select the scale resolution.
[Decimal Place]: Check the checkbox to show the value after decimal point.
[Mathematical Sign]: Check the checkbox to show the minus sign (-) when the value
is a negative figure.
• [Drift And Radius]
[Title]: Enter the title of the component.
• [Dual Azimuth Promotion]
[Title]: Enter the title of the component.
[Location]: Select the position of thruster ([FORE] or [AFT]).
[Title]: Enter the title to show at the top of the indicator.
[Degree]
[Actual]: Set the source of the angle which the needle of the outer periphery points
to. (feedback angle of the thruster)
[Order]: Set the source of the angle which the needle of the inner periphery points
to. (actual azimuth of the thruster)
[Unit]: Enter the unit of measurement for the azimuth of the thruster.
[RPM]/[MW]/[Lever]
A maximum of three data can be displayed under the indicator.
[Label]: Enter the name of the data shown beneath the analog indicator.
[Source]: Set the source of the data that appears beneath the analog indicator.
[Unit]: Enter the unit for the data that appears beneath the analog indicator
• [Dual Dial Meter]
[Title]: Enter the title of the component.
1-66