Furuno FAR-3210 Instruction Manual page 32

1. INITIAL SETTING AND ADJUSTMENT
9. Click [Digital Output] on the menu bar.
[Channel 01-01] to [Channel 10-08] are shown on the display. Each sensor adapt-
er MC-3030D has eight input ports. When one sensor adapter MC-3030D is con-
nected to the MC-3000S, [Channel 01-01] to [Channel 01-08] can be used. When
ten sensor adapters MC-3030D are connected, [Channel 01-01] to [Channel 10-
08] can be used.
The connector no. on the MC-3030D board and the corresponding channel no.
are shown below.
Connector No.
Connector No.
10. Check the checkbox for [Channel No.] to set the items referring to step 12 of
section 1.4.2.
11. Click [Analog Input] on the menu bar.
[Channel 01] to [Channel 15] are shown on the display. Each sensor adapter MC-
3010A has three input ports. When one sensor adapter MC-3010A is connected
to the MC-3000S, [Channel 01] to [Channel 03] can be used. When five sensor
adapters MC-3010A are connected, [Channel 01] to [Channel 15] can be used.
The connector no. on the MC-3010A board and corresponding serial port no. are
shown in the following table.
1-26
No.1 sensor adapter MC-3030D
Channel No.
Channel 01-01
J3
Channel 01-02
Channel 01-03
J4
Channel 01-04
No.2 sensor adapter MC-3030D
Channel No.
Channel 02-01
J3
Channel 02-02
Channel 02-03
J4
Channel 02-04
Connector No. Channel No.
Channel 01-05
J5
Channel 01-06
Channel 01-07
J6
Channel 01-08
Connector No. Channel No.
Channel 02-05
J5
Channel 02-06
Channel 02-07
J6
Channel 02-08