Furuno FAR-3210 Instruction Manual page 26

1. INITIAL SETTING AND ADJUSTMENT
Pin No.
5, 6
7, 8
9, 10
11, 12
15, 16 or 14, 15
8. Check the checkbox of [Channel No.].
9. Set the items referring to the following table.
Item
[Data Category] Sets the data category. Settings: [ALERT], [ACK], [BUZZER STOP], [OPERA-
TOR FITNESS], [OTHER], [GYRO SELECTOR], [MOB].
[+] button This appears when the [Data Category] is set to [ALERT]. Click to show the con-
figuration of the alert input.
• [Equipment ID]: The Equipment ID is shown.
• [Alert ID]: The alert notification sentence* (ALF or ALR) and alert number are
• [
• [Alert Name]: The alert name is
[Equipment ID] Select the Equipment ID from the pull-down list. This appears when the [Data
Category] is set to [ACK] or [BUZZER STOP].
The pull-down list options change according to the setting at [Sensor Setting].
[Details] • [Name]: Enter the appropriate sensor name.
• [Data Type]: Set the contact input ([Normally
• [Input Time (100msec)]: Set the input time
• [Dead Band (100msec)]: Set the dead band
• [Calibration Active]: Keep the default setting.
• [Active Status (1)], [Active Status (0)]: Keep
1-20
Direction
Output
Output
Output
Output
Input
Example: ALR is the alert notification sentence.
shown. When the alert notification sentence is ALF, the instance ID is shown.
*: According to the connected sensors.
] button: Opens the [Alert
No. Setting] window to select
the input alert. The following ex-
ample uses the alert notification
sentence ALR. Select the
Equipment ID for the connected
sensors from the [Equipment
ID] pull-down list. Then check
the radio button of the desired
alert and click the [OK] button.
shown.
Open] or [Normally Closed]).
(recommended value: 5).
after input (recommended value: 50).
(Default: without check)
the default setting.
Channel No.
Channel 01 Normal Close
Channel 02 Normal Close
Channel 03 Normal Open
Channel 04 Normal Open
Channel 01 Depended on the configuration.
Remarks
CRA001
Contact Status