Ccrs] Menu; How To Select The [Data Source] - Furuno FAR-3210 Instruction Manual

<Sentence Filter setting>
Set the [Sentence Filter Setting] window as
shown in the right figure to limit input to the
HBT, ACN (ACK) sentences.
• Filter:
AMS can send ACN: ACN, HBT
AMS can send ACK: ACK
Note 1: Check [Input Sentence Filter Enable].
Note 2: To place no input limit on the Talker, en-
ter ** (wild card).
1.5

[CCRS] Menu

1.5.1

How to select the [Data Source]

1. Access the [Common Installation Setting] menu and click [CCRS] on the tab bar.
2. Click [Position] of [Data Source Setting] on the menu bar.
*: Position, Heading, STW, COG/SOG, Rate of Turn: Keep the default
setting (3000). For other than the above settings, set "30000" (30 sec.).
3. Select the data source in order of priority from the [Data Source] pull-down list.
The Equipment IDs checked at [Installation Parameters] menu are shown on the
pull-down list.
When entering the data source, the [Formatter] is automatically entered.
Note: When more than two [Data Source] and [Formatter] are entered, the top-
most entry has the highest priority.
4. Set [Time], [Depth(Bow)], [Depth(Midship)], [Depth(Stern)], [Heading], [Rudder],
[Wind Speed/Direction], [STW(absolute)] (speed through water), [STW(position)]
(speed through ground), [COG/SOG], [Heading Magnetic], [Water Temperature],
[Current], and [Rate of Turn] similarly.
Note: For the processor unit of the chart radar, the default data sources are as
follows:
Position
Time
Depth(Bow)
Depth(Midship)
Depth(Stern)
Heading
Rudder
Serial 07 Setting
Item
GPS001
GPS001
-----
-----
-----
GYO001
-----
1. INITIAL SETTING AND ADJUSTMENT
Cancel
Data Source
OK
* *
Remarks
1-35