Furuno FAR-3210 Instruction Manual page 13

Note 2: If the MU-201, MU-231CE or the monitor of Hatteland Display is connect-
ed, the optional cable DSUB9P-X2-A-L5M/L10M for brilliance control is required
to connect.
4. Select the monitor type and resolution connected to the DVI3 port from the [Type
Number] pull-down list of DVI3.
When the processor unit is not connected to the VDR or you do not use the dual
display, select [Not Connected (NONE)] and go to step 8.
5. Select the display data to output from the DVI3 port from the [Output Mode] pull-
down list.
Setting option
[Clone] DVI1 to DVI3 ports output the same resolution and display data.
The DVI1 port can switch chart radar and conning display data.
Note 1: When [Clone] is selected, the [Type Number] for DVI1 and
DVI3 port should be same setting option.
Note 2: Set to [Clone] to connect the chart radar with a VDR.
[Independent] Cannot be selected.
6. When one of the following monitors is selected at step 3, click the [Run] button for
[Monitor Color Calibration] to perform the color calibration. For all other monitors,
go to step 8.
• [HD 19T21MMD (SXGA)]
• [HD 24T21MMD (FHD)]
• [HD 24T21MMD (WUXGA)]
• [HD 24T22FUD (FHD)]
• [HD 24T22FUD (WUXGA)]
• [HD 26T21MMD (WUXGA)]
• [HD 26T22MMD (WUXGA)]
"Processing" appears at the next to the [Run] button during the color calibration.
After completing the calibration, check result appears ([Succeeded] or [Failed]).
When the check result is [Succeeded], the following confirmation message ap-
pears. Click the [OK] button to reboot the system and apply the calibration setting.
When the check result is [Failed], retry the color calibration. If the error is not rec-
tified, contact your dealer.
Note: Be sure to perform the color calibration. If the calibration is not performed,
you cannot adjust the monitor brilliance.
7. Access the [Common Installation Setting] menu and open the [Peripherals] win-
dow again.
8. Select the type of the printer from the [Printer Model] pull-down menu.
Setting option
[HP Officejet Pro 8000]
[HP Officejet Pro 8100]
[HP Officejet Pro 8210]
1. INITIAL SETTING AND ADJUSTMENT
Remarks
• [HD 26T22FUD (WUXGA)]
• [HD 27T22FUD (FHD)]
• [HD 27T22FUD (WUXGA)]
• [HD 32T22FUD (FHD)]
• [HD 32T22FUD (WUXGA)]
• [HD 55T22FUD (FHD)]
• [HD 55T22FUD (WUXGA)]
Connect the printer to LAN1 port or USB port, and then
set the IP address of the printer to "192.168.31.241".
For how to set the IP address of the printer, see the op-
erator's manual of the printer.
Remarks
1-7