Provisioning And Configuring The Ase Card; Ase Operational Commands - Ericsson SmartEdge 600 Hardware Manual

7.2

Provisioning and Configuring the ASE Card

The following steps give a brief overview of how to provision and configure
applicable SmartEdge chassis for the ASE card:
1. To provision a chassis for the ASE card, use either the NetOp Element
2. To monitor the progress of provisioning the chassis for the ASE card, use
3. To configure the ASE card for IPSec VPNs, you must use the NetOp EMS
7.3

ASE Operational Commands

The following are ASE operational commands:
•
•
•
•
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
Management System (EMS) or the card ase
For information about how to use ASE with the NetOp EMS Security
Services software to implement, monitor, and manage IPSec VPN
configuration and deployment in your network, see related documentation
at https://ebusiness.ericsson.net.
the show chassis command.
Automatic processing copies the ASE software to the ASPs during
provisioning. Reissue the command until it shows you that the ASPs are
up and running.
Security Services software.
show asp—Shows the status of the ASPs after the ASE card has been
configured.
Note: ASP status will show only if the ASE card has been provisioned in
the chassis and the XCRP is correctly configured.
—Shuts down and reloads ASE software to the ASPs.
reload card
slot
Note: This operation can take several minutes to complete.
show tech-support ase—Displays information that helps your
technical support representative resolve issues on the ASE card. The
information contains software version information, system uptime, task
information, configuration information, and current state of each line card
show chassis—Shows slots that ASE cards are installed in and the state
of the ASE cards:
Advanced Services Engine
CLI command.
slot
161