4-Port Advanced Gigabit Ethernet Card - Ericsson SmartEdge 600 Hardware Manual

Table 116 Equipment LEDs on 4-Port Gigabit Ethernet Card
Label Activity
ACTIVE On
Off
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 117 Facility LEDs on 4-Port Gigabit Ethernet Card
Label Activity
ACT On
Off
LNK On
Off
6.12

4-Port Advanced Gigabit Ethernet Card

The 4-port Advanced Gigabit Ethernet card is the second version of the Gigabit
Ethernet card. This Advanced Gigabit Ethernet card provides four optical
Ethernet ports and supports 512 MB for each PPA.
This card is the same size as all other SmartEdge line cards and occupies
a single slot in the chassis. The following types of GBIC transceivers are
supported on any of the ports:
• 1000Base-SX—Short Reach
• 1000Base-LX—Long Reach
• 1000Base-LX70—Extended Reach
• 1000Base-TX—Copper
Either card can have any combination of the listed types of GBIC transceivers
installed.
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the transceivers purchased from Ericsson.
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
Color Description
Green This card is in service.
None This card has failed (the FAIL LED is on).
Color Description
Yellow The link is transmitting or receiving frames.
None The link has no active frame.
Green The link is up.
None The link is down.
Caution!
Card Descriptions
137