Leds - Ericsson SmartEdge 600 Hardware Manual

SmartEdge 600 Router Hardware Guide
7.1

LEDs

Figure 54
Table 152 Equipment LEDs on the ASE Card
Label Activity
FAIL On
Off
ACTIVE On
Off
STDBY On
Off
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 153 Facility LEDs for the ASE Card
Label Activity
LNK ACT On
On
Off
SPD On
On
On
(1) The default condition for no link or cable attached is yellow.
(2) The LED shows green for both 10 and 1000 Mbps.
160
LEDs on ASE Card
Color Description
Red A failure exists on the card.
None No failure exists on the card.
Green This card is in service.
None This card is on standby (the STDBY LED is on) or has failed (the FAIL LED is
on).
Yellow This card is on standby.
None This card is in service (the ACTIVE LED is on) or has failed (the FAIL LED is
on).
Color Description
Green The link is present and active.
Blinking The link is transmitting or receiving frames.
None The link has no active frame.
(1)
Yellow The link is operating at 100 Mbps.
Green The link is operating at 1000 Mbps.
Green The link is operating at 10 Mbps.
(1)
(2)
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09