Select The Rack - Ericsson SmartEdge 600 Hardware Manual

Table 8 SmartEdge 600 Connections
Card Connections
Management workstation (LAN)
Craft console (RS-232)
External Timing, Primary and Secondary (DS-1 or E1)
Modem, SL7 and SL8 (RS-232)
(4)
Alarm
(4)
Status/Ctl
Power and chassis ground
Advanced Services Engine
(1) The 20-port GE1020 card requires two adjacent slots.
(2) The front panel has five MRJ21 connectors, each supporting 12 FE ports; a breakout cable, which uses RJ-45
connectors for the individual ports, is available from Ericsson.
(3) Connector type is determined by the gigabit interface converter (GBIC) version installed in the port.
(4) The SmartEdge OS does not support this connection.
1.6

Select the Rack

You can mount the SmartEdge 600 chassis in a standard 19- or 23-inch rack.
Brackets for the 23-inch rack are not shipped with the chassis but are available
in the bracket spares kit (NTM 101 1517/1).
Risk of equipment damage. Never install the chassis in a rack that has not
been stabilized by being bolted to the floor and to the ceiling and always select
a mounting position that is suitable to the type of rack in which the chassis
is being installed.
The SmartEdge 600 chassis requires 7 RUs—1.75 inches (4.50 cm). The
optional AC shelf at the bottom of the rack requires 1 RU; a stand-alone
external fuse panel requires 1 RU.
Note: Ericsson does not supply fuse panels.
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
Connector Type
RJ-45, front chassis access
DB-9, front chassis access
DB-9, rear chassis access
(4)
DB-25, rear chassis access
DB-25, rear chassis access
DB-37, rear chassis access
1/4-20 threaded holes on 0.625-inch (1.59 cm) centers,
rear chassis access
RJ-45, front chassis access
Caution!
Site Preparation
7