20-Port Gigabit Ethernet Card - Ericsson SmartEdge 600 Hardware Manual

Table 135 Equipment LEDs on 5-Port Gigabit Ethernet Card
Label Activity
ACTIVE On
Off
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 136 Facility LEDs on 5-Port Gigabit Ethernet Card
Label Activity
ACT On
Off
LNK On
Off
6.17

20-Port Gigabit Ethernet Card

The 20-port Gigabit Ethernet (GE) card is designed to be used as a
subscriber-facing module and as well as a network uplink module. This card is
based on the third generation of the PPAs and has increased memory capacity
with a maximum throughput of 20 Gbps and increased port density compared
with previous GE cards. It supports up to 48K circuits per card.
This card is the same size as all other SmartEdge line cards and occupies a
single slot in the chassis. The following types of SFP optical transceivers are
supported on any of the ports:
• 100Base-FX—Short Reach
• 1000Base-SX—Short Reach
• 1000Base-LX—Long Reach
• 1000Base-ZX—Extended Reach
• 1000Base-TX—Copper
• 1000Base-CWDM—Coarse wavelength-division multiplexing
• 1000Base-DWDM—Dense wavelength-division multiplexing
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09
Color Description
Green This card is in service.
None This card has failed (the FAIL LED is on).
Color Description
Yellow The link is transmitting or receiving frames.
None The link has no active frame.
Green The link is up.
None The link is down.
Card Descriptions
149