5-Port Gigabit Ethernet Card - Ericsson SmartEdge 600 Hardware Manual

SmartEdge 600 Router Hardware Guide
Table 130 Equipment LEDs on 20-Port Gigabit Ethernet 1020 Card
Label Activity
ACTIVE On
Off
(1) A failure can be total, partial, or forced. Failure on any part of the card, including failure of any of its ports, results in
the FAIL LED being on.
Table 131 Facility LEDs on 20-Port Gigabit Ethernet 1020 Card
Label Activity
ACT On
Off
LNK On
Off
6.16

5-Port Gigabit Ethernet Card

The 5-port Gigabit Ethernet card is designed for traffic management with the
second generation of the PPAs, each of which supports 1 GB of memory and
can process data internally at a much higher rate than the PPAs on the first
and second versions of the Gigabit Ethernet card.
This card is the same size as all other SmartEdge line cards and occupies a
single slot in the chassis. The following types of SFP optical transceivers are
supported on any of the ports:
•
•
•
•
•
•
146
Color
Green
None
Color
Yellow
None
Green
None
1000Base-SX—Short Reach
1000Base-LX—Long Reach
1000Base-ZX—Extended Reach
1000Base-TX—Copper
1000Base-CWDM—Coarse wavelength-division multiplexing (CWDM)
1000Base-DWDM—Dense wavelength-division multiplexing (DWDM)
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the transceivers purchased from Ericsson.
Description
This card is in service.
This card has failed (the FAIL LED is on).
Description
The link is transmitting or receiving frames.
The link has no active frame.
The link is up.
The link is down.
Caution!
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09