Getting Ready To Build - Dremel 3D45 Operating And Safety Instructions Manual

DM 160992A425AA 07-17_3D45 7/7/17 11:21 AM Page 23
Observe
WARNING
!
warnings
instructions when using the Dremel 3D45.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not touch the extruder
WARNING
!
tip or
platform during Dremel 3D45 operation or
until it has cooled down to at least 60°C
(140°F). Contact with the extruder tip or
build platform during or after operation before
tip and build platform has cooled may result
in personal injury.
Use only DREMEL filament.
WARNING
!
Use of
authorized by Dremel may result in
equipment, property damage, or personal
injury.
Do not adjust extruder
WARNING
!
setting to exceed the
maximum rated temperature of the
filament type being used. Heating filament
above recommended range can cause
emissions that may result in personal injury.
Do not pull the filament
CAUTION
!
out. Doing so may damage
the extruder.
FIG. 1
Open

Getting Ready to Build

all provided LOADING/CHANGING FILAMENT
and safety
1. Start filament load/change process by
tapping "Filament" button on touch screen.
Extruder will move to front right corner of
print area and extruder tip will begin to heat.
heated build
2. After extruder stops moving, open the
filament not 3D45 Lid for better access to extruder.
3. If existing filament is loaded, cut existing
filament near extruder intake and tap the
arrow button on touch screen.
Spool
Holder
Filament
Close
DV-160992A425, Page: MUL (VAA), downloaded at: 2017.12.19_18:02:13, by PT-RT/MKP2_Karan.Patel
23
Filament
Guide Tube