Building - Dremel 3D45 Operating And Safety Instructions Manual

DM 160992A425AA 07-17_3D45 7/7/17 11:21 AM Page 28
28
CONNECTING USB CABLE
1. Ensure 3D45 power switch is in the off
position.
2. Connect the included USB cable to your
3D45 and computer, figure 5.
3. Open software.
4. Turn your Dremel 3D45 on using the
power switch to sync your computer to
your Dremel 3D45.
CONNECTING ETHERNET
1. Ensure 3D45 power switch is in the off
position.
2. Plug ethernet cable into your 3D45,
figure 6.
3. Turn your Dremel 3D45 on using the
power switch. Ethernet connection should
be detected automatically. Tap "Accept" to
confirm connection.
Observe
WARNING
!
warnings
instructions when using the Dremel 3D45.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not reach inside the
WARNING
!
Dremel 3D45 while it is in
operation. Contact with Dremel 3D45 moving
parts during operation may result in poor build
quality, equipment damage or personal injury.
NOTE: Your Dremel 3D45 will build test
objects before leaving the factory. These test
objects may have been made with a different
filament color than you are using. Therefore,
Getting Ready to Build
FIG. 5
FIG. 6

Building

all provided a small amount of filament may be remaining
and safety in the extruder. The start of your first object
may have some of this filament color until it
transitions over to your filament color.
You have several options when building on
your 3D45:
1) On-Printer Storage
2) USB Flash Drive
3) Online Print Queue
4) Computer
DV-160992A425, Page: MUL (VAA), downloaded at: 2017.12.19_18:02:16, by PT-RT/MKP2_Karan.Patel
USB
Ethernet