Removing Your Object - Dremel 3D45 Operating And Safety Instructions Manual

DM 160992A425AA 07-17_3D45 7/7/17 11:21 AM Page 31
REMOVING YOUR OBJECT FROM THE
BUILD PLATFORM
Do not touch the extruder
WARNING
!
tip or
platform during Dremel 3D45 operation or
until it has cooled down to at least 60°C
(140°F). Contact with the extruder tip or
build platform during or after operation before
tip and build platform has cooled may result
in personal injury.
Use personal protective
WARNING
!
equipment. The use of
protective equipment such as heat resistant
gloves and safety glasses will reduce
personal injuries.
Be aware of your body
WARNING
!
position when using hand
tools to remove objects from the build
platform. Sudden tool slip and improper
body position during object removal from the
build platform may result in personal injury.
Do not drop the build
WARNING
!
platform. Tempered glass
plate may break and result in personal injury.
Do not twist or bend the
WARNING
!
build platform
removing objects. Tempered glass plate
may separate from plastic holder and result
in personal injury.
Avoid scratching the build
CAUTION
!
platform when removing
objects. Scratches in the build platform will
result in improper object creation.

Removing Your Object

heated build
Removal
1. Wait for the extruder or build platform to
cool before removing your object.
2. With the object still attached, remove build
platform from the build area.
3. Peel your object from the build platform. If
needed, gently use the object removal tool
to remove object from build platform
(figure 8).
while
REMOVING SUPPORTS
Use needle nose pliers to remove supports
that are inside your object or hard to reach.
DV-160992A425, Page: MUL (VAA), downloaded at: 2017.12.19_18:02:18, by PT-RT/MKP2_Karan.Patel
31
FIG. 8
Tool
(IF REQUIRED)