Getting Ready To Build - Dremel 3D20 Quick Start Manual

a) If the leveling sheet cannot slide between the extruder
and build platform, turn the knob counterclockwise until
you can slide the leveling sheet between the extruder and
build platform with some resistance.
3
Getting to Know Your Dremel 3D20
b) If the leveling sheet can slide between the extruder and
build platform too easily, turn the knob clockwise until you
can slide the leveling sheet between the extruder and build
platform with some resistance.
4. Tap "Next" to move the build platform toward the right knob
and repeat step above.
5 Tap "Next" to move the build platform toward the rear knob
and repeat step above.
6. Tap "Finish" to complete the leveling process.
7
15
16
14
6
Building
BUILDING OUT OF THE BOX
1. Go back to the main screen on your touch screen and insert
SD card included with your Dremel 3D20.
9 11 10 12
2. Tap "Build" on the touch screen, tap the SD card option, and
use the up/down arrows to scroll.
3. Tap on the model file you would like to build and tap "Build".
4. Your Dremel 3D20 will align the extruder with the build
platform and will begin heating the extruder.
5. Once the build temperature is reached, your model will
begin to build.
4

Getting Ready to Build

6. Touch screen will display "Object Finished" . Tap the check
box to confirm. Wait until the touch screen indicates that
the extruder temperature is "COOL" .
OBSERVE ALL PROVIDED WARNINGS AND SAFETY
WARNING WARNING
INSTRUCTIONS WHEN USING THE DREMEL 3D20.
8
1
6
2
4
3
13
17 18
1
1. Lid
3
2. Door
3. Touch Screen
4. Build Platform
WARM
STEP 2: RIGHT ADJUSTMENT
5. Build Platform Clips
6. Filament Spool
NEXT
7. Filament Spool Holder/Lock
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER 8. Extruder Tip
BACK
THE BUILD PLATFORM
4
9. Extruder Fan
5
10. Extruder
11. Extruder Intake
12. X-Axis Guide Rails
13. Stepper motor (1 of 3)
14. Z-Axis Guide rail
15. Filament Guide Tube
16. Y-Axis Guide Rails
17. SD card Input
18. USB Input
19 20
19. Power Switch
20. Power Input
1
3
2
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
WARM
STEP 3: BACK ADJUSTMENT
NEXT
TURN LEFT TO RAISE
THE BUILD PLATFORM
TURN RIGHT TO LOWER
BACK
THE BUILD PLATFORM
5
2
5